Installing Windows 2003 Support Tools; Microsoft Certificate Authority Services; Windows 2003 Support Tools Installation - Motorola 2.1 Networking Setup Manual

Chapter 2: Network Setup
Select the Install software automatically radio button from the Hardware Update Wizard
9
and click Next
Be sure the hardware update wizard locates the HP NC7782 Gigabit Server driver on the HP
10
Smart Start CD follow the wizard prompts to install the driver.
After the first driver is installed, repeat steps 8-10 to continue configuring the second Ethernet
11
Controller.
Select Start | Control Panel | Network Connection | Local Area Connection
12
Select Properties button from Local Area Connection Status window
13
Highlight the Internet Protocol (TCP/IP) line and select Properties.
14
In the Internet Protocol (TCP/IP) Properties panel:
15
1.
2.
3.
4.
5.
6.
7.

Installing Windows 2003 Support Tools

The following procedure provides installation instructions for Windows 2003 Support Tools.
Procedure 2-5

Windows 2003 Support Tools Installation

Re-insert the Windows 2003 Server Installation media.
16
Be sure NOT to trigger a re-install or update of Windows 2003.
17
Select the Perform Additional Tasks option.
18
Select Browse this CD.
19
Enter the \Support\Tools\ folder.
20
Double-click on SUPTOOLS.MSI and follow all on-screen instructions.
21

Microsoft Certificate Authority Services

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The end result will be two configured network adapters. However,
AFTER the Ethernet Controller drivers are configured, the next step is to
configure a single LAN network connection (as described in the
following steps).
Select the Use the following address radio button
Enter an IP address of 172.31.0.21.
Enter a Subnet mask of 255.255.0.0
Enter a Default gateway of 172.31.0.2
Select the Use the following DNS server addresses radio button
Enter a Preferred DNS server address of 172.31.0.20
Click the OK button
2-24