Figure 9-16 Power Cable Pulled Through The Plug Shell And Under The Stress Relief Bar; Figure 9-17 Wire Base Is Not Visible On The Right Side Of The Stress Relief Bar - Motorola 2.1 Networking Setup Manual

Appendix A:
2.
Pull the three wires through the rear of the plug until they are visible in front of the plug.
Figure 9-16
3.
Press the wire base under the Strain Relief Bar so that the main cable is not visible on the other side
of it.
Figure 9-17
4.
Tighten the two Strain Relief Bar Screws to lock the cable in place.
Power cable pulled through the Plug Shell and Under the Stress Relief Bar
Wire Base is Not Visible on the Right Side of the Stress Relief Bar
9-17