Part Ii - Power Cable With Flying Leads; Part Iii - Power Connector And Cable Assembly Instructions; Figure 9-3 Feed Flying Lead Cable Through Components; Figure 9-4 Attach Flying Lead Cable To The Plug - Motorola 2.1 Networking Setup Manual

Appendix A:
Part II – Power Cable with Flying Leads
2.
The initial Power Cable will have four wires, cut the Red Wire back, as it is not used.
Figure 9-3
NOTE: Be sure to cut the RED WIRE Back as it in not used
Part III – Power Connector and Cable Assembly Instructions
3.
Place the Connector parts over the Power Cable as shown below.
Figure 9-4
Feed flying lead cable through components
Attach flying lead cable to the plug
9-11