Table of Contents
Advertisement
Connecting Hardware Devices
6
Close the drive bay latch—applying a small amount of pressure to seat the HDD/
drive tray assembly into position.
Closing the drive bay latch
7
Close the server's upper door and lower door panel.
8
Plug the power cable into an AC outlet (or UPS) and set the AC switches (EPS-R
models only) to On.
9
Press the power button to turn on the server, then run any required system checks.
You may need to change some operating system and/or application software settings
after installing an additional hard disk drive.
Replacing a hard disk drive
This section provides information and instructions for replacing a hard disk drive in
Toshiba Magnia 3200 servers with and without RAID controllers.
If the server has a RAID controller
The number of hard disk drives that can fail without affecting system operation depends
on RAID configuration of your server. If a hard disk drive fails, replace it as quickly as
possible and rebuild the disk array.
If your server is equipped with a RAID controller configured for data redundancy and
a hard disk drive fails, the system will go into a "downgraded operational state" and
continue to run. However, if a second device fails, important programs or data may be
destroyed or lost.
Installing a hard disk drive
87
Advertisement
Table of Contents
