Table of Contents
Advertisement
System Configuration Setup
I/O Device Configuration
On Board Devices
Installed O/S: [Win2000]
Reset Configuration Data: [No]
Large Disk Access Mode: [DOS]
Local Bus IDE Adapter: [Enabled]
PS/2 Mouse: [Auto Detect]
Multiprocessor Specifications [1.4]
Summary Screen: [Disabled]
USB BIOS Legacy Support: [Disabled]
I/O Device Configuration
Sets up I/O devices. The following submenu options are available:
Serial port A
Specifies the serial port A setting.
Serial port B
Specifies the serial port B setting.
Parallel port:
Specifies the parallel port mode.
Mode:
Sets the operation mode for the serial port; select "ECP."
Floppy disk controller:
Specifies whether the floppy disk controller is enabled or disabled.
Base I/O Address:
Sets the I/O port address for the floppy disk controller.
BIOS Setup Utility
: Auto
: Auto
: Auto
: ECP
: Enabled
: Primary
102
Advertisement
Table of Contents
