Kenwood 3750-X Hardware Installation Manual page 74

Installing a DC Power Supply
Figure 3-9
Use the ground screw to attach the single-ground lug to the switch rear panel. Use two ground screws to
Step 5
attach the dual-hole lug to the switch rear panel
Using a ratcheting torque screwdriver, torque the ground-lug screws to 60 lbf-in. (960 ozf-in.).
Step 6
Step 7 Connect the other end of the grounding wire to an appropriate grounding point at your site or to the rack.
Figure 3-10
1 Single-ground screw and lug ring
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
3-10
Crimping the Ground Lug
Attaching the Ground Lug and Wire Assembly
1
C O N S O
L E
S T A C K
2
C O N S O
L E
S T A C K
Chapter 3 Power Supply and Fan Module Installation
(Figure 3-10).
A U X
R E S E T
1
S T A C K
2
A U X
R E S E T
1
S T A C K
2
2 Dual-ground adaptor and dual-hole lug
OL-19593-03