Kenwood 3750-X Hardware Installation Manual page 16

Front Panel Description
For information about the network modules, see the
on page
SFP and SFP+ Modules
The SFP and SFP+ modules provide copper or fiber-optic connections to other devices. These
transceiver modules are field-replaceable, providing the uplink interfaces when installed in an SFP
module slot. The SFP modules have LC connectors for fiber-optic connections or RJ-45 connectors for
copper connections.
Use only Cisco SFP modules on the switch.
The (downlink) SFP module slots on the Catalyst 3750-X-12S and Catalyst 3750-X-24S switch front
Note
panel support any combination of standard SFP modules. SFP+ modules are not supported.
Table 1-4
Part Number
GLC-GE-100FX=
GLC-LH-SM=
GLC-LH-SMD=
GLC-SX-MM=
GLC-SX-MMD=
GLC-T=
GLC-ZX-SM=
GLC-BX-D=
GLC-BX-U=
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
1-8
2-22. For cable specifications, see
Supported Cisco SFP Modules
Description
1,2,3
100FX SFP on GE SFP ports for LAN switches
GE SFP, LC connector LX/LH transceiver
GE SFP, LC connector LX/LH transceiver, extended operating temperature
range
GE SFP, LC connector SX transceiver
GE SFP, LC connector SX transceiver, extended operating temperature
range
1, 3
1000BASE-T SFP transceiver module for copper connections
1000BASE-ZX SFP module for SMF, 1550 nm
1
1000BASE-BX10 SFP module for single-strand SMF, 1490-nm TX,
1310-nm RX wavelength
1
1000BASE-BX10 SFP module for single-strand SMF, 1310-nm TX,
1490-nm RX wavelength
"Installing a Network Module in the Switch" section
Appendix B, "Connector and Cable Specifications."
Chapter 1 Product Overview
OL-19593-03