Table of Contents
Advertisement
Chapter 2
Switch Installation
When you complete the switch installation, see the
for more information about switch configuration.
Table- or Shelf-Mounting
To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis (see
Figure 2-18
CO NS OL
S TA C K
1
When you complete the switch installation, see the
for more information switch configuration.
After Installing the Switch
After the switch is installed, you might need to:
•
•
•
Connecting to the StackWise Ports (Catalyst 3750-X Switches)
Before connecting the StackWise cables, review the
Switches)" section on page
OL-19593-03
Attaching the Adhesive Pads for Table- or Shelf-Mounting
E
AU X
RE SE T
1
S TA C K
2
S-P WR
XP S
S-P WR
1
Adhesive pads
Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
Use the CLI setup program to enter the initial switch configuration. See
the Switch with the CLI-Based Setup Program."
Connect to the front-panel ports. See the
page 2-22
and the
"Connecting Devices to the Ethernet Ports" section on page
2-5. Always use a Cisco-approved StackWise cable to connect the switches.
Connecting to the StackWise Ports (Catalyst 3750-X Switches)
"After Installing the Switch" section on page 2-19
AC OK
PS OK
C3 KX -P
WR -71 5W
AC
AC OK
PS OK
C3 KX -P
WR -71 5W
AC
"After Installing the Switch" section on page 2-19
"Installing a Network Module in the Switch" section on
"Planning a Switch Data Stack (Catalyst 3750-X
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
Figure
2-18).
1
Appendix C, "Configuring
2-26.
2-19
Advertisement
Table of Contents
