Installing The Switch; Rack-Mounting - Kenwood 3750-X Hardware Installation Manual

Chapter 2 Switch Installation
Figure 2-14
STACK 1
STACK 1
STACK 1

Installing the Switch

•
•
•
The illustrations shown in this section show the Catalyst 3750-X-48 PoE switch as an example. You can
install the Catalyst 3750-X and 3560-X switches following the same procedures.

Rack-Mounting

To install the switch in a 19-inch rack, follow the instructions described in this section.
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
The 19-inch brackets are included with the switch. Installing the switch in other rack types requires an
optional bracket kit not included with the switch.
numbers.
OL-19593-03
Example of a Partitioned StackPower Stack with a Failover Condition
1
STACK 2
STACK 2
2
STACK 2
Rack-Mounting, page 2-15
Table- or Shelf-Mounting, page 2-19
After Installing the Switch, page 2-19
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack. Statement 1006
Figure 2-15 shows the mounting brackets and part
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
Installing the Switch
2-15