Epson STYLUS PRO 7450 Unpacking & Setup Instructions page 22

❏ Adjust the feed strength by pressing the
Paper Feed buttons on the control panel.
When using thick, heavy, or curled paper,
press the Paper Feed u button to
increase the power. When using thin or
light paper, press the Paper Feed d
button to decrease the power.
❏ If the paper does not come out even after
executing the procedure above, open the
front cover and pull the paper out
manually.
9. Holding the bottom edge of the paper, turn the
roll paper to remove slack. Make sure that the
bottom edge of the paper is straight, and that
it is aligned with the horizontal line.
Note:
You do not have to align the right end of the paper
with the vertical line.
20
10. Set the paper lever to the secured position, and
close the roll paper cover. PRESS PAUSE
BUTTON appears.
11. Press the Pause button.
The printer heads move and the paper
automatically feeds into the printing position.
READY appears on the LCD panel.
Note:
Even if you do not press the Pause
print heads move and paper feeds into the printing
position automatically. READY appears on the LCD
panel.
Now you are ready to print on roll paper. Make
the printer driver settings, then send the print job.
(See the User's Guide for detailed informations).
Note:
❏ Allow time for the ink to dry thoroughly after
printing to ensure the printout quality.
❏ If you do not use the paper set above, remove it from
the printer. When you use roll paper, set the paper
lever to the released position, and wind it up. When
you use cut sheet, remove the paper from the printer
and store it separately.
button, the