Troubleshooting - Champion Power Equipment 92750 Owner's Manual And Operating Instructions

TROUBLESHOOTING

Problem
Engine will not start
Engine starts but runs roughly
Engine shuts down during operation
Engine cannot supply enough power or
overheating
Wedge movement is slow or erratic
Oil leak from hose connection
Oil leak from cylinder
Wedge will not extend or retract
Wedge does not Auto-Return
Excessive bouncing while towing
For further technical support:
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
tech@championpowerequipment .com
17
REV 92750-20131216
Cause
No fuel
Faulty spark plug
Unit loaded during startup
Low oil level
Choke in the wrong position
Spark plug wire loose
Out of fuel
Low oil level
Insufficient ventilation
Air in the hydraulic oil system
Debris lodged in beam guides
Low hydraulic oil
Loose hose clamp or hydraulic fitting
Faulty cylinder rod seal
Scored or bent cylinder rod
Loose hydraulic fitting
Faulty combination washer seal on
cylinder hydraulic fitting
Faulty control valve
Faulty hydraulic pump
Low hydraulic oil
Low hydraulic oil
Faulty control valve
Under-inflated tires
ENGLISH
Solution
Add fuel
Replace spark plug
Remove load from unit
Fill crankcase to the proper level
Place log splitter on a flat, level surface
Adjust choke
Attach wire to spark plug
Fill fuel tank
Fill crankcase to the proper level
Place log splitter on a flat, level
surface
Check for air restriction . Move to a
well ventilated area
Purge air by extending and retracting
the wedge several times until motion
is smooth
Clear debris from beam
Check oil level and add as needed
Tighten hose clamp or hydraulic fitting
Contact Customer Service
Contact Customer Service
Tighten hydraulic fitting
Contact Customer Service
Contact Customer Service
Contact Customer Service
Check oil level and add as needed
Check oil level and add as needed
Contact Customer Service
Inflate tires to proper pressure . Refer
to tire sidewall
92750