Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Champion Power Equipment 92050-1
Summary of Contents for Champion Power Equipment 92050-1
- Page 1 OWNER’S MANUAL 20 Ton LOG SPLITTER MODEL NUMBER 92050-1 12039 Smith Ave. SAVE THESE INSTRUCTIONS Santa Fe Springs CA 90670 Important safety instructions USA / 1-877-338-0999 MADE IN CHINA are included in this manual. REV 92050-1-20170520 www.championpowerequipment.com...
- Page 2 AN IMPORTANT MESSAGE ABOUT TEMPERATURE: Your Champion Power Equipment product is designed and rated for continuous operation at ambient temperatures up to 40°C (104°F). When your product is needed your product may be operated at temperatures ranging from -15°C (5°F) to 50°C (122°F) for short periods.
-
Page 3: Table Of Contents
92050-1 20 Ton LOG SPLITTER TABLE OF CONTENTS Introduction ......Maintenance and Storage . -
Page 4: Introduction
ENGLISH INTRODUCTION Congratulations on your purchase of a Champion Power Equipment product. Champion Power Equipment and Champion Engine Technology designs, builds, and supports all of our products to strict specifications and guidelines. With proper product knowledge, safe use, and regular maintenance, this product should bring years of satisfying service. -
Page 5: Manual Conventions
92050-1 ENGLISH MANUAL CONVENTIONS This manual uses the following symbols to help differentiate between different kinds of information. The safety symbol is used with a key word to alert you to potential hazards in operating and owning power equipment. Follow all safety messages to avoid or reduce the risk of serious injury or death. -
Page 6: Safety Rules
92050-1 ENGLISH SAFETY RULES WARNING DANGER Read this manual thoroughly before operating your Sparks can result in fire or electrical shock. log splitter. Failure to follow instructions could result in serious injury or death. When servicing the engine: Disconnect the spark plug wire and place it where it cannot contact the plug. - Page 7 92050-1 ENGLISH SAFETY RULES DANGER DANGER Fuel and fuel vapours are highly flammable and Skin injection hazard. High-pressure hydraulic oil extremely explosive. can inject under your skin. Fire or explosion can cause severe burns or death. Unintentional startup can result in entanglement, Make sure all fittings are tightly secure before...
-
Page 8: Training
92050-1 ENGLISH SAFETY RULES Training Preparation 1. Read the Operator’s Manual completely before 1. Be thoroughly familiar with all controls and with attempting to use this log splitter. proper use of the equipment. 2. Do not allow anyone to operate your log splitter who 2. -
Page 9: Operation
92050-1 ENGLISH SAFETY RULES Operation Maintenance and Storage 1. Before starting this log splitter, review all safety 1. Always shut off the power source while repairing or rules. Failure to follow these rules may result in adjusting the splitter except as recommended by the serious injury to the operator or bystanders. -
Page 10: Controls And Features
92050-1 ENGLISH CONTROLS AND FEATURES Read this owner’s manual before operating your log splitter. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference. Log Splitter 5.1 cm (2 in.) Ball Coupler – For towing the log Log Catchers splitter behind your vehicle. -
Page 11: Assembly
92050-1 ENGLISH ASSEMBLY 3) Install the Wheels Your log splitter is requires some assembly. If you have any questions regarding the assembly of your 1. Place bearings in the wheel hub log splitter, call our help line at 1-877-338-0999. Please 2. -
Page 12: Install The Cylinder And Wedge
92050-1 ENGLISH ASSEMBLY 4) Install the Beam Cont’d. 5) Install the Cylinder and Wedge 1. Place the wedge on the beam between the cylinder CAUTION mounts and slide it forward into the rails. (A) 2. Remove the cylinder mounting plates. (A) Beam is heavy. -
Page 13: Install The Engine And Hoses
92050-1 ENGLISH ASSEMBLY 6) Install the Engine and Hoses 6) Install the Engine and Hoses Cont’d. 4. Connect one end of the clear oil hose to the hydraulic CAUTION oil tank just beneath the engine and the other end to the pump inlet on the bottom of the pump. -
Page 14: Add Engine Oil
92050-1 ENGLISH ASSEMBLY Add Engine Oil Add Oil Cont’d. NOTE CAUTION Synthetic oil may be used after the 5 hour initial break- DO NOT attempt to crank or start the engine before it in period. Using synthetic oil does not increase the has been properly filled with the recommended type and... -
Page 15: Add Engine Fuel
92050-1 ENGLISH ASSEMBLY Add Engine Fuel Add Engine Fuel Cont’d. 1. Use clean, fresh, regular unleaded fuel with a WARNING minimum octane rating of 85 and an ethanol content of less than 10% by volume. Pouring fuel too fast through the fuel screen may 2. -
Page 16: Operation
92050-1 ENGLISH OPERATION Before Each Use Inspect the Log Splitter Log Splitter Location Cont’d. 1. Check the hydraulic oil level and visually inspect all hoses, attachments and cylinder for leaks, cracks, fraying or other damage. 2. DO NOT operate the log splitter if there is any indication of damage or oily residue. -
Page 17: Starting The Engine
92050-1 ENGLISH OPERATION Log Splitter Location Cont’d. Starting the Engine Cont’d. WARNING NOTE If the engine starts, but does not run, make certain ALWAYS use the log splitter for its intended use. The that the log splitter is on a flat, level surface. The... -
Page 18: Log Splitter Operation
To alleviate high altitude issues other than the natural 2. Block tires and put support leg in the DOWN position power loss, Champion Power Equipment can provide a to prevent unintended movement of the log splitter high altitude carburetor main jet. The alternative main during operation. -
Page 19: Maintenance And Storage
92050-1 ENGLISH MAINTENANCE AND STORAGE Spark Plugs The owner/operator is responsible for all periodic maintenance. 1. Remove the spark plug cable from the spark plug. 2. Inspect the electrode on the plug. It must be clean WARNING and not worn to produce the spark required for ignition. -
Page 20: Maintenance Schedule
*To be performed by knowledgeable, experienced owners, any small 6. Clean the engine according to the maintenance section. engine repair shop, or Champion Power Equipment certified dealers. 7. Change the oil. 8. Remove the spark plug and pour about 1⁄2 ounce Log Splitter Maintenance (14.8 mL) of oil into the cylinder. -
Page 21: Specifications
92050-1 ENGLISH SPECIFICATIONS Log Splitter Specifications Oil Cont’d. – Ram Force ......20 Ton Degrees Celsiusº (Outside) –... -
Page 22: Parts Diagram
92050-1 ENGLISH SPECIFICATIONS Parts Diagram... -
Page 23: Parts List
92050-1 ENGLISH Part Number Description Part Number Description PMJ22J-02-00 Beam ASME B18.2.1 1996 Bolt 5/16"-24×1" GB/T 5782-2000 PMJ22G-29 Engine Bushing BOLT M12×75(12.9) (M12×75) 26.110 Engine PMJ22J-04-00 Wedge Slide GB/T 1096-1979 Flat Key 5x5 GB/T 95-2000 (ø12) Washer ø12 PMJ22G-28 Engine Connector GB/T 889.1-2000... -
Page 24: Engine Parts Diagram
92050-1 ENGLISH SPECIFICATIONS Engine Parts Diagram... -
Page 25: Engine Parts List
92050-1 ENGLISH Part Number Description Part Number Description 1.5789.0608 Flange Bolt M6×8 1.5789.0855 Flange Bolt M8×55 22.061100.00.2 Recoil Starter Cover, Black 23.040017.00 Oil Seal, Valve 21.061005.00 Recoil Starter Spring 21.040003.00 Spring, Valve 2.10.003 Rope (Ø5×1550) 21.040007.00 Retainer, Exhaust Valve Spring 21.061001.01... -
Page 26: Troubleshooting
92050-1 ENGLISH TROUBLESHOOTING Problem Cause Solution Engine will not start. No fuel. Add fuel. Faulty spark plug. Replace spark plug. Unit loaded during startup. Remove load from unit. Engine will not start; Low oil level. Fill crankcase to the proper level. -
Page 27: Other Exclusions
Warranty Qualifications – Failures due to acts of God and other force majeure events Champion Power Equipment (CPE) will register this warranty upon beyond the manufacturer’s control. receipt of your Warranty Registration Card and a copy of your sales –... - Page 28 Champion Power Equipment, Inc (CPE) and Environment and Climate Change Canada (ECCC) Emission Control System Warranty Your Champion Power Equipment (CPE) engine complies with Environment and Climate Change Canada (ECCC) emission regulations. YOUR WARRANTY RIGHTS AND OBLIGATIONS: CPE is pleased to explain the Emission Control Systems Warranty on your 2017 small off-road engine.
- Page 29 EMISSION CONTROL SYSTEM WARRANTY The following are specific provisions relative to your Emission Control System Warranty Coverage. Emission Control System Warranty (ECS Warranty): 1. APPLICABILITY: The ECS Warranty Period shall begin on the date the new engine or equipment is delivered to its original, end-use purchaser, and shall continue for 24 consecutive months thereafter.
- Page 30 Champion Power Equipment dealer who is authorized by Champion Power Equipment, Inc. to sell and service that CPE product during his normal business hours. Claims for repair or adjustment found to be caused solely by defects in material or workmanship will not be denied because the engine was not properly maintained and used.
Need help?
Do you have a question about the 92050-1 and is the answer not in the manual?
Questions and answers