Table of Contents
Advertisement
To access a menu using the MENU button:
1
2
1.
Press MENU. The Wipe Pattern buttons
illuminate.
2.
Press a Pattern button to select the
corresponding menu.
Auto-Follow
Auto-follow displays the menu for a selected function
when the button for that function is pressed.
Auto-follow is always active — when you press any
button on the control panel that has a corresponding
menu, the menu is automatically displayed.
Menu Navigation
Some menus have multiple pages. When the NEXT
button is lit, multiple menu pages exist. Press NEXT
to move to the next menu page. Press and hold
NEXT and then press MENU to move to the previous
menu page.
Some menus contain sub-menus. Press the knob
corresponding to the sub-menu to access it. Press
and hold the NEXT button and then press the
RECALL button to return from the sub-menu.
If you wish to return to the first page of a top-level
menu, Press and hold the NEXT button and then
press the STORE button.
Note:
• You can exit the menu system by pressing any
button other than a Wipe Pattern or source button
while the menu system is active.
Knobs
The control panel has three continuously rotatable
pushbutton knobs located below the display screen.
The knobs are used to select and alter menu options.
To use the knobs:
• Rotate the knob to adjust the corresponding value.
To default a value using the knobs:
• Double-press a knob to default the value currently
associated with that knob.
Buttons
The buttons illuminate to indicate one of four states:
• Glow — When a button on the board is lit with the
Panel Glow color, it is in a resting state. All buttons
are lit with the Panel Glow color unless selected,
turned on, in use, or on-air.
• On-air — Source buttons corresponding to on-air
sources are red.
• Menu — A button is green when the associated
menu is displayed.
• On/Selected — Several buttons are On/Off
buttons. If the button feature is turned off, it is lit
with the Panel Glow color. If the button feature is
turned on, the button is lit with a brighter shade of
the Panel Glow color.
For More Information on...
• adjusting the panel glow, refer to the section
"Customizing the Panel Glow" on page 15.
Button Inserts
Insert films can be installed into most switcher
buttons. Insert films allow you to name specific
source buttons, control buttons, or replace the default
button names with those of a different language.
Installing Your Own Insert Films
All inserts must be cut to the dimensions indicated for
small (1) or large (2) buttons. Using insert films that
do not meet the recommended criteria may
damage the button cap and diffuser.
0.444"
1
0.504"
Figure 5 Insert Sizing
0.468"
2
0.528"
3
Hide quick links:
Advertisement
Table of Contents
