Reset Options - JVC KM-H3000 User Manual

Reset Options

You can restore the entire switcher or individual
settings to default values. Menu items can also be
reset.
You can also capture the state of the switcher as a
user-defined default, allowing you to reset to those
settings at any time.
You switcher is shipped with the following default
settings:
Table 3 Switcher Default Settings
Item
Selected Source (all buses)
Key Types
Clip
Gain
Transition Limit
Key Status
Media-Store Channels
Matte Color
Wash
Selecte Wipe Pattern
Wipe Parameters
Transition Type
Masks
Main Transition rate
Key Transition rate
Chroma Key
Output Sync
Frame Sync
Power Save
34
Default Value
Black
Auto-Select
Linear
Linear
None
Off-air
Empty
Hue: 30.5%
Sat: 100%
Lum: 50%
Off
Top-Left Pattern Button
Clip: 0.0%
Gain: 0.0%
Transp: 0.0%
Invert: Off
Dissolve
Off
59.94 Hz Video
Formats: 15 frames
50 Hz Video Formats:
13 frames
59.94 Hz Video
Formats: 8 frames
50 Hz Video Formats: 7
frames
Edge: 0.0%
Shadow: 100.0%,
Gain: 100.0%
Spill: 0.0%.
Off
Off
20 min
Note:
• Default transition rates vary depending on the
frequency of the selected video format.
Configuring Default Settings
You can customize any of the default parameters and
save them as a user-defined default.
To configure user-defined defaults:
2
3
1. Configure any of the settings in the previous list
as desired. This will become the new default
state.
2. Press MENU.
3. Press the RESET Wipe Pattern button.
4. Press the Aux knob to toggle between including
or excluding the Aux buses in the reset.
5. Press the RState Save knob to save the new
default settings.
6. Press the Confrm knob to commit the save.
Press the Cancel knob to cancel the save and
return to the previous setting.
Restoring Default Settings to Factory State
You can restore user-defined default settings to a
factory state. This is useful if you wish to begin
creating a new user-defined default from a known
starting configuration.
To restore user-defined default settings to the
factory state:
1
2 3
1. Press MENU.
2. Press the RESET Wipe Pattern button.
3. Press NEXT.
4. Press the Dfault RState knob to restore the
user-defined defaults to factory settings.
5 4
4