Cautions / Disassembly For Repair; Disassembly For Repair - Kenwood DVF-3200-S Service Manual

CAUTIONS / DISASSEMBLY FOR REPAIR

CAUTIONS
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interfe rence unless the
modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change
or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful inter-
ference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guar antee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television rece ption, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
sures:
— — Reorient or relocate the receiving antenna.
— — Increase the separation between the equipment and receiver.
— — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— — Consult the dealer or an experienced radio / TV technician for help.
For Canada
NOTICE: This Class B digital apparatus complies with Canadian ICES-003.

DISASSEMBLY FOR REPAIR

Fig.
1) Insert and push a Driver in the emergency eject
hole(A) at the right side, or put the Driver on the
Lever(B) of the Gear Emergency and pull the Lever(B)
in direction of arrow so that the Tray Disc is ejected
about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
How to Reset Parental Lock.
1. Connect the TV set to DVF-3200 or 3250.
2. Push the power switch of DVF-3200 or 3250 to be on.
3. Check the display of DVF-3200 or 3250 shown "NO DISC".
4. Push the "SETUP" key of remote control and TV has "set up
menu"
5. Select the "16:9" on TV.
6. Push #key 1 3 9 7 1 3 9 and ENTER.
Push #key again if mistype.
7. Push the power switch of DVF-3200 or 3250 to be off.
DVF-3200
following mea-
3