Configure Time Settings - Toshiba IP4100 Installation Manual

GENERAL SYSTEM CONFIGURATION

Configure Time Settings

Figure 1-11 Checking Time Settings Updates
IP4100 Install Sept., 2013
1. In the left hand panel, select Time. This opens the Time Settings
screen.
2. In the Time Server field, enter the IP address or URL of the server
that distributes reference clock information for your network. This
server must be visible to the base stations at all times.
3. In the Time server refresh interval field, change the number of hours
the base should wait before it checks the time server again. The
recommended value is 24.
4. In the Timezone field, select the number of hours the local time zone
differs from GMT/UTC time. For example, US Central Standard Time
(CST) is 6 hours behind UTC, so you would set the Timezone field to
-6:00.
5. Enter any necessary settings for Daylight Savings Time, then click
Save & Reboot. (If you need more information on these fields, refer
to Chapter 3 – Software
6. After the base station reboots, verify the time settings updates. Refer
to Figure 1-11.
– Check the Home/Status screen to be sure the time has updated
correctly.
– Check the Time screen to verify that the time server IP address is
still correct.
Configure Time Settings
Reference.)
1-15