Gears of the duplexing drive assembly are not fixed on the plate. Remove
with care not to make them fall apart.
Points to note when attaching
Be sure to install the black gear [2] to the side where a left-direction arrow
[1] is marked.
[1]
[2]
3.1.8 Operation Panel Unit
3.1.8.1 Preparation for detaching the control panel
LBP3370 / LBP3310
1) Detach the left cover.(page 3-2)Reference [Detaching the left cover]
2) Detach the right cover.(page 3-1)Reference [Detaching the right cover]
3) Remove the rear cover unit.(page 3-1)Reference [Removing the rear
cover unit]
3.1.8.2 Detaching the control panel
LBP3310
1) Remove the parts below.
- 1 screw [1]
- 1 clamp [2]
- 1 connector [3]
[2]
2) Detach the upper cover unit [1] together with the control panel.
- 2 screws [2] (to be loosened)
- 2 screws [3]
[3]
[1]
F-3-26
[2]
3) Free the harness [2] from the guide [1].
[1]
0018-2644
4) Detach the control panel [1].
- 1 claw [2]
0018-2642
5) Detach the control panel [1].
- 1 connector [2]
[1]
[3]
F-3-27
[2]
[1]
F-3-28
[1]
F-3-29
Chapter 3
[2]
[2]
3-7