Hardware Installation; Wall Mount - Ubiquiti UniFi UAP-AC-PRO Quick Start Manual

Hardware Installation

The UniFi AP can be mounted on the wall or ceiling. Perform
the steps for the appropriate installation:

Wall Mount

1. Position the Mounting Bracket at the desired location on
the wall with the Arrow pointing up.
2. Mark the four mounting holes, and use a 6 mm drill bit to
drill the holes.
3. If your Ethernet cable feeds through the wall, cut or drill a
circle approximately 18 mm in diameter (as shown below).
Then feed the CAT5/6 cable through the hole.
www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
Arrow
Optional 18 mm Hole for
Ethernet Cable Feed through the Wall