Know Your Electric Pressure Washer
Read the owner's manual and safety instructions carefully before operating the electric pressure washer. Compare the illustration
below to the electric pressure washer in order to familiarize yourself with the location of the various controls and adjustments.
Save this manual for future reference.
1. Safety lock (Locate lock in center of trigger. Pull up and snap in place. See Fig. 20, pg. 10)
2. Trigger
3. Transport handle
4. High-pressure hose connection
5. Trigger gun
6. Spray wand
7. Water inlet (garden hose connection)
8. Spray wand protector
9. High-pressure hose
10. Garden hose adaptor (female coupler)
11. Needle clean-out tool
12. 0º Quick-Connect nozzle (orange)
13. 15º Quick-Connect nozzle (yellow)
14. 25º Quick-Connect nozzle (green)
15. 40º Quick-Connect nozzle (gray)
16. Soap Quick-Connect nozzle (black)
17. Detergent selection dial
18. Removable detergent tanks
19. Hose holder
20. On/Off switch
21. Power cord with GFCI
22. Cord holder
23. Onboard storage for Quick-Connect nozzles
24. Detergent tube
25. Trigger gun holder
26. Water outlet
(high-pressure connection)
27. Wheels
Technical Data
Rated Voltage
Motor
Max. Water Inlet Temperature
Max. Water Inlet Pressure
Max. Rated Flow
1
4
5
6
7
8
9
120 V ~ 60 Hz
14.5 amp (1800 W)
104ºF/40ºC
0.7 MPa
1.76 GPM
2
3
17
18
19
20
21
(FRONT)
10
11
Rated Pressure
Max. Pressure
Hose Length
Power Cord Length
Weight
5
22
26
(REAR)
12
13
14
15
1450 PSI
2030 PSI
20 ft (6 m)
35 ft (10.7 m)
31 lbs (14 kg)
23
24
25
27
16
Need help?
Do you have a question about the SPX3000 and is the answer not in the manual?
Questions and answers
Where is the fuse on a SunJoe SPX3000?
When under pressure water gushes from under the plastic causal where the red arrow is pointing. I've replaced the washer and it continues to leak.
Your Sun Joe SPX3000 may be leaking water from under the plastic casing due to internal hose or reservoir tank issues. Users have reported that internal hoses or the reservoir tank leak badly, preventing water from gathering properly. This issue occurs even without electricity being used. If replacing the washer did not fix the problem, the leak might be coming from an internal component that needs inspection or replacement.
This answer is automatically generated
Machine won't start
The Sun Joe SPX3000 machine may not start due to the following reasons:
- Power failure or not plugged in: Ensure the machine is connected to a working outlet.
- Defective socket: Check the power cord, reset the GFCI, and try a different outlet.
- Blown fuse: Replace the fuse and turn off other machines using the same circuit.
- Defective extension cord: Try running the unit without an extension cord.
This answer is automatically generated
The circular scrubber will not turn
The circular scrubber on the Sun Joe SPX3000 may not turn if there is low water pressure, air in the pump, or a blockage in the hose or nozzle. It could also be due to a malfunction in the attachment or insufficient flow caused by a faulty connection. Ensure all hoses are airtight, the nozzle is clean, and the water supply is adequate.
This answer is automatically generated
When you are looking at the back of the pressure washer with the back removed you can see that water is leaking on the left side of the aluminum housing. The pressure washer was drained and stored in a heated basement all winter. How can I replace this part and how much will it cost?