Toro Groundsmaster
4000?D Service Manual page 194

PRELIMINARY – For Toro Distributor and Toro Company use only.
9. Install steering cylinder to axle assembly (see Steer-
ing Cylinder in the Service and Repairs section of Chap-
ter 4 − Hydraulic System).
10.Install hydraulic motor to axle assembly (see Rear
Axle Motor in the Service and Repairs section of Chap-
ter 4 − Hydraulic System).
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury.
11. Install wheels to axle. Torque wheel lug nuts from 85
to 100 ft−lb (115 to 135 N−m).
12.Lower machine to ground.
13.Fill axle with SAE 85W−140 weight gear lube. Lubri-
cant capacity is approximately 80 fl. oz. (2.37 l) for the
axle and 16 fl. oz. (.47 l) for the gearbox.
14.Check rear wheel toe−in and adjust if necessary.
15.Check steering stop bolt adjustment. When the
steering cylinder is fully extended (right turn), a gap of
1/16" (1.6 mm) should exist between bevel gear case
casting and stop bolt on left axle case. Figure 12 shows
stop bolt location.
Axles, Planetaries and Brakes
WARNING
1. Steering stop bolt
Page 6 − 14
1
Figure 12
2. Bevel gear case (LH)
Groundsmaster 4000−D
2