Toro Groundsmaster
4000?D Service Manual page 110

PRELIMINARY – For Toro Distributor and Toro Company use only.
Hydraulic Manifold: Flow Divider
RIGHT
FRONT
1. Hydraulic manifold
2. O−ring
3. Hydraulic fitting
4. Bracket
5. Flange nut
6. Cap screw (2 used)
7. Hydraulic hose
Removal (Fig. 56)
NOTE: The ports on the manifold are marked for easy
identification of hydraulic line connections. Example: P
is the traction pump connection port and M1 is the con-
nection for the front traction motors (See Hydraulic
Schematics to identify the function of the hydraulic lines
and cartridge valves at each port).
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Hydraulic System
8
7
11
5
8. O−ring
o
9. 90 hydraulic elbow
10. O−ring
11. Hydraulic hose
12. Hydraulic fitting
13. O−ring
Page 4 − 76
9
10
15
14
13
12
8
Figure 56
2. Disconnect hydraulic lines from manifold and put
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper reassembly.
3. Remove hydraulic manifold from the frame using
Figure 56 as guide.
Installation (Fig. 56)
1. Install hydraulic manifold to the frame using Figure
56 as guide.
2. Remove caps and plugs from fittings and hoses.
Properly connect hydraulic lines to manifold.
16
17
2
5
4
6
14. O−ring
o
15. 90 hydraulic elbow
16. O−ring
17. Cap screw
18. O−ring
19. Hydraulic fitting
Groundsmaster 4000−D
18
19
1
2
3