JVC MX-GT98V Service Manual page 8

MX-GT98V/MX-GT95V/MX-GT88V
MX-GT85V/MX-G78V/MX-G75V
Removing the tuner board
Prior to performing the following procedure, remove
the metal cover.
1. Disconnect the card wire from connector CN1 on the
tuner board on the right side of the body.
2. Remove the plastic rivet fixing the tuner board.
3. Remove the two screws G on the back of the body.
Removing the rear cover / rear panel
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
1. Remove the screw H attaching the rear cover on the
back of the body.
2. Push each tab of the four joints b in the direction of
the arrow and release.
3. Remove the fifteen screws G
panel.
4. Disengage the joints c on each lower side of the rear
panel using a screwdriver and remove the rear panel
backward.
Joint c
Fig.16
1-8
(See Fig.12)
(See Fig.13 to 16)
attaching the rear
Rear panel
Tuner board
CN1
Plastic rivet
Fig.12
G
Joint b
Rear cover
Fig.13
G
G
G
Fig.14
Rear panel
Fig.15
Rear panel
G
H
Rear panel
Joint b
Rear panel
G
G
Joint c