JVC MX-GT98V Service Manual page 24

MX-GT98V/MX-GT95V/MX-GT88V
MX-GT85V/MX-G78V/MX-G75V
Removing the actuator motor and belt
1. Remove the two screws I retaining the gear bracket
2. While pressing the pawl "t" fixing the gear bracket in the
arrow direction, remove the gear bracket
3. From the notch "u section" on the chassis assembly
fixing the edge of gear bracket, remove and take out the
gear bracket(See Fig. 19).
4. Remove the belts respectively from the right and left
actuator motor pulleys and pulley gears(See Fig. 18).
5. After turning over the chassis assembly, remove the
actuator motor while spreading the four pawls "v" fixing
the right and left actuator motors in the arrow
direction(See Fig. 20).
[Note] When the chassis assembly is turned over under
the conditions wherein the gear bracket and belt
have been removed, then the pulley gear as well
as the gear, etc. constituting the gear unit can
possibly be separated to pieces. In such a case,
assemble these parts by referring to the assembly
and configuration diagram in Fig. 21.
Chassis assembly
Assembly and Configuration Diagram
1-24
(See Fig.18~21)
(See Fig.18).
(See Fig.18).
u
Gear bracket
Fig.19
Pulley gear
Gear B
Gear C
Gear bracket
Pulley gear
Belt
Motor pulley
v
Pulley gear
Gear B
Gross gear U
Select gear
Gear C
Gross gear L
Fig.21
Pulley gear
Belt
Motor pulley
I
t
Pawl
I
Fig.18
Actuator motor
Fig.20
Cylinder gear
v