Table of Contents
Advertisement
NOTE:
Check the value of "switchname" in "switchshow" to check that the 8G FC Switch is
subject to zoning.
2) Creating zone
Use the "zonecreate" command to create a zone.
Format of "zonecreate" command
zonecreate
(1) zonename:
Specify a zone name with it enclosed by double quotation marks (").
(2) member:
Specify a domain ID and a port number (decimal) with them delimited by a comma (,).
NOTE:
Delimit the zone name and the first port with a comma (,).
Delimit adjacent port specifications with a semicolon (;).
IMPORTANT:
A zone name can be up to 64 alphanumeric characters.
This command must be done by the number of zones to be created.
Use the "zonecreate" command on the console screen to create zones.
3.
ALE044120T2:admin> zonecreate "zone1","1,0;1,1"
ALE044120T2:admin> zonecreate "zone2","1,2;1,3"
ALE044120T2:admin> zonecreate "zone3","1,4;1,5"
ALE044120T2:admin> zonecreate "zone4","1,6;1,7"
NOTE:
Any commands used on the switch console should be specified with lowercase letters.
Type "zoneshow" command on the console screen.
4.
ALE044120T2:admin> zoneshow
Defined configuration:
zone:
zone1
zone:
zone2
zone:
zone3
zone:
zone4
Effective configuration:
no configuration in effect
ALE044120T2:admin>
"zonename" ,
"member;member;member"
(1)
1,0; 1,1
1,2; 1,3
1,4; 1,5
1,6; 1,7
(2)
- 176 -
Advertisement
Table of Contents
