Depending on the usage environ- ment, this odor may be noticed from Thank you for purchasing the SHARP FU- the exhaust port in several months. 888SV. Please read the instruction manual In this case, purchase the optional carefully for correct usage.
Fire, electrical shock and/or injury may occur as a result. For repair, contact your dealer or the nearest Sharp Service Center. • Periodically remove dust from the power plug Accumulated dust on the power plug may cause bad insulation from humidity, etc.
CAUTIONS CONCERNING THE USAGE OF THIS PRODUCT • Do not block the intake and exhaust ports. • Do not use the unit near or on hot objects, such as a stove, etc. Also, do not use the unit where it may come into contact with steam.
PARTS NAMES MAIN UNIT DISPLAY Filter replacement lamp Tobacco smoke removal operation lamp Power lamp (Light up when the power plug is AUTO operation lamp Pollen removal operation lamp inserted into the wall outlet) OFF timer indication lamps Fan speed lamps (preset by remote control) Plasmacluster High...
CLUSTER ION LAMP Cluster ion operation can be selected using the remote control. Blue light When the cluster ion operation is in the Clean mode or AUTO cluster ion mode and the air in the room is dirty, the light turns on and the unit will operate in the Clean mode. Green light When the cluster ion operation is in the Refresh mode or AUTO cluster ion mode and the air in the room is clean, the light turns on and the unit will operate in the Refresh...
INSTALLATION HOW TO MOUNT THE UNIT ON HOW TO PUT THE UNIT ON A A WALL TABLE MOUNTING THE STAND CAUTIONS Remove the front panel. WHEN MOUNTING THIS • At the same time, also remove the pre- PRODUCT TO A WALL filter, stamina-power carbon and the HEPA filter.
Page 9
Inatall mounting bracket 1 on the Place the 2 cushion gum wall • Install it after consulting a specialist and you can get the confirmation of the strength. • Mount the bracket using the included wood screws (long screws) so that it levels. Use 4 wood screws (long screws) Cushion gum (2 pieces) Mount the main unit...
PREPARATION Be sure to remove the power plug from the wall outlet. INSTALLING THE FILTERS To maintain the quality of the filters, they are pre-installed in the main unit and covered with plastic bags. Be sure to remove the filters from the plastic bags before using the unit. Remove the filters Place the unit with its front side facing up...
Tabs HEPA filter Install the filter Takeout the HEPA filter from the plastic bag and install it into the main unit with the display facing upward. Insert in the direction so that the tabs on the HEPA filter are facing toward you. Proper operation cannot be achieved if the filter is installed on a wrong side.
OPERATION For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the conditions of the air. If operation is set to ON during this time, the Clean sign lamp will alternately flash in green, orange and red.
A remote Filter reset button controller is sometimes damaged when it is pressed In the initial operation, the with the point of a sharp Cluster ion mode is also set object. as AUTO. It can’t remove the noxious substances (carbon monoxide etc.) of cigarette.
CARE AND MAINTENANCE (To maintain the best performance of this product, please clean the unit periodically.) When cleaning, be sure to remove the power plug from the wall outlet. In addition, never handle the power plug with wet hands. Electrical shock and injury may occur as a result. MAIN UNIT FILTERS Clean off the dirt on the main unit and the...
REPLACING THE FILTERS The filter replacement period is indicated by the filter replacement lamp. (The lamp will light up in about 5 years, when using the unit for 12 hours daily.) • The operation hours are saved in memory even when removing the power plug for transpor- tation to another room, etc.
TROUBLESHOOTING Before calling for repair, check the symptoms below for possible remedies, since the problem may not be a malfunction of the unit. SYMPTOM REMEDY (not a malfunction) The remote control does not • Have the batteries depleted? • Are the batteries inserted with correct polarity? function •...