Hitachi AJ-S55KXP User Manual page 8

Installation Guide (continued)
Installation of Washing Machine
1
Adjust the instability of the washing
machine with adjustable leg.
Fixed leg
Adjustable leg
Inspection of trial run
Put some water into the washing barrel and reconfirm its
horizontality.
The ground is level if all front, rear, left and right height difference between
the spinning hole and water surface are less than 3mm.
To install the machine on an inclined floor, leg caps in the attached accessory kit can be used to adjust height by
connecting them to the fixed leg.
Confirming the machine type of AJ-S55KXP, please install the water drninage hose and hang it on, otherwise there
will be no water in washing basket.
AJ-S55KXP
How to Use the Adjustable Leg
1 Loosen the lock nut by unscrewing in
arrow direction 1 before using the
adjustable leg to stabilize unit.
Loosening
Elevating
8
(B C )
9
1
Lock nut
Adjustable leg
Lowering
2
Please make sure of the horizontality of the
washing machine.
As shown in the figure, the horizontality can be easily
observed by the string used to hang an object.
It is level if the
clearance between A
and machine body is
the same with that
string
between A and the
machine body.
A
A
object
Spinning hole
3mm
2 After adjusting of the unit, tighten
the lock nut by screwing it in arrow
direction.
Plastic base
Tighten the lock nut until it reaches the plastic base.
At most 40mm
40mm
A
(front or
profile)
A
B C
2
Tightening
Lock nut
Maximum adjust able
range is 40mm.