Canon VB150 User Manual page 40

c
Note
39
For the packet target address in the connection keeping function, we
recommend that you consider the impact on traffic conditions and set the IP
address that is nearest after the auto dial-up router.
Click the [OK] button to change the settings. To discard the changes, click the
[Cancel] button. This returns you to the settings title page.
Static Route Control
Route settings are required
communicating with a wide-area network
through a router. When using Ethernet or
wireless LAN together with PPP, set the
route as needed.
"Default Route"
Specify the route that would normally be
used. A gateway address is required if a
router on the Ethernet or the wireless LAN
side is used.
"Route 1-3"
Use this setting if you require connection
routes other than the normal route. You
can select from Ethernet, wireless LAN or
PPP as the interface. Specify the
destination route in the Destination and
Mask fields. You must specify a gateway
address if you are using a router on an
Ethernet or wireless LAN network.
Connection Keeping
When this is selected, an ICMP Echo
packet is transmitted periodically to a
specified address in order to maintain the
network connection.
"Send packet regularly"
Tick this check box to enable this function.
"Target Address"
Specify where the packet should be sent.
"Interval(min.)"
In minutes from 1 to 60, specify the
interval at which packet should be sent.
when