Related Manuals for Hyco Aquila IN96T
Summary of Contents for Hyco Aquila IN96T
- Page 1 Product Instruction Manual Aquila IN96T 9.6kW Instantaneous inline water heater Version 3.2 Jan 2015 V15.6/4...
-
Page 2: Important Safety Points
Thank you for purchasing a Hyco instantaneous water heater. Instantaneous water heaters are very energy efficient since they only consume energy when they are used and so have no standing losses. The IN96T is a mains pressure multipoint instantaneous water heater with electronic temperature control, designed for handwashing at one or two basins, dishwashing at a single sink and can also be used for a single shower. -
Page 3: Installation
2. Installation Wall Mounting • Do not install in areas where there is a risk of water freezing in the heater. • Do not install the heater where the consequences of a leak could be unusually severe. (eg above computer equipment) •... - Page 4 Before attaching the heater to the wall, consider the wiring route to the heater. The electrical cable can enter the heater through the opening in the back for concealed cabling. Knock out panels in the top right corner of the back plate and front cover are available for side entry.
- Page 5 Make the plumbing connections as indicated on the front cover of the heater: • Inlet (cold mains) • Outlet (hot tap/outlet) The inlet is the right hand pipe and the outlet the left, when viewed from the front. The supplied gauze should be installed into the cold inlet side of the plumbing. All pipework should be adequately earthed.
- Page 6 Electrical Do not commence electrical installation before connecting the heater to the water supply and verifying there are no leaks or air gaps. Electrical installation must be carried out by a qualified electrician in accordance with the latest edition of the IEE wiring regulations. Electrical supply should be capable of isolation via a double poled switch.
-
Page 7: Operation
CUT OUT 3. Operation • Once installed and connected to the electrical supply the heater is ready for use. TANK • Once turned on the heater will automatically power up when it detects a flow of water through it (min 2.5L/m). •... -
Page 8: Maintenance
Setting the maximum flow rate The flow rate is shown on the front display of the heater in L/min. If the desired temperature cannot be met at the current flow rate the temperature display will flash to indicate this. Adjust the flow down using the dial on the front of the heater until the temperature display stops flashing. -
Page 9: Specifications
5. Specifications Power supply 230V ~ 50Hz Dimensions H380 x W230 x D90mm Power 9600W Protection class IPX4 Rated Current Min/Max temperature setting 30/60°C Over heat protection temperature 75°C +/-5 Minimum operating flow rate 2.5L/Min Minimum operating pressure 0.1MPa Maximum rated pressure 0.75MPa Required Water resistivity 1300Ω/cm... -
Page 10: Troubleshooting
6. Troubleshooting Defect Possible cause Action Water is too hot Temperature set too Turn down the temperature high on the heater on the heater (see section 6.1). Water is too cold Water flow rate is Decrease flow rate too high (see section 6.2). - Page 11 This product is guaranteed against faulty materials and manufacture for a period of one year from the date of purchase. Hyco will in its sole discretion replace, repair or refund any faulty unit. Incorrect installation and failure to follow correct operating instructions are excluded.
- Page 12 In order to underline the duty to dispose of this equipment separately, the product is marked with a crossed out dustbin. Hyco Manufacturing Ltd Normandy Court Express Way...
Need help?
Do you have a question about the Aquila IN96T and is the answer not in the manual?
Questions and answers