Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt D28710-XE
Summary of Contents for DeWalt D28710-XE
- Page 1 INSTRUCTION MANUAL D28710-XE HEAVY-DUTY 355 mm (14") CHOP SAW...
- Page 3 • SECURE THE WORKPIECE. Use clamps or a vise to hold the workpiece on the table and against the fence Definitions: Safety Guidelines or when your hand will be dangerously close to the blade (within 6"). It is safer than using your hand and it The definitions below describe the level of severity for each signal word.
-
Page 4: Electrical Connection
• When starting the tool with a new or replacement wheel or if you are unsure of the condition of the wheel, Electrical Connection hold the tool in a well protected area and let it run for one minute. If the wheel has an undetected crack or The electric motor has been designed for one voltage only. - Page 5 MAXIMUM CUTTING CAPACITY Spark Deflector Adjustment (Fig. 1) NOTE: Capacity shown on chart assumes no wheel wear and optimum fence position. To best deflect sparks away from surrounding persons and materials, loosen the screw (B), adjust the spark deflector (C) and then retighten screw. Do not allow cordset to come into contact with deflector or sparks as damage to cordset may occur.
-
Page 6: Maintenance
When making a miter cut, the vise (F) may not clamp securely, depending on the thickness of the workpiece and FIG. 9 FIG. 10 the miter angle. Other aids (such as spring, bar or C-clamps) will be necessary to secure the workpiece to the fence when making these cuts. -
Page 7: Troubleshooting Guide
Cleaning TROUBLESHOOTING GUIDE WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear AS/NZS51337 approved eye protection when performing this. TROUBLE! TOOL WILL NOT START WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. - Page 8 701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia 1800 444 224 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.com.nz (NOV11) Part No. N140356 D28710-XE Copyright © 2011 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...
Need help?
Do you have a question about the D28710-XE and is the answer not in the manual?
Questions and answers