LLDP Commands
show lldp interfaces tlvs-overloading
show lldp interfaces tlvs-overloading
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To show the status of LLDP TLVs overloading for specific interfaces, use the show
lldp interfaces tlvs-overloading Privileged EXEC mode command.
Syntax
show lldp interfaces
Parameters
•
interface-id
—An interface ID or a list of interface IDs.
Command Mode
Privileged EXEC mode
User Guidelines
When an LLDP packet contains too much information for one packet, this is called
overloading.
The command calculates the overloading status of the current LLDP configuration,
not for the last LLDP packet that was sent.
Example
switchxxxxxx# show lldp interfaces gi11 tlvs-overloading
gi11:
TLVs Group
---------------------------- + ------- + ----------------
LLDP-MED Capabilities |
LLDP-MED Network Policies |
Total: 69 bytes
Left: 1419 bytes
interface-id
tlvs-overloading
|
Bytes
Mandatory |
22 |
9 |
10 |
Optional |
20 |
802.1 |
8 |
|
Status
Transmitted
Transmitted
Transmitted
Transmitted
Transmitted
22
338