LLDP Commands
lldp med tlv-select
lldp med tlv-select
lldp receive
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To specify which LLDP MED TLVs are included, use the lldp med tlv-select
Interface Configuration mode command.
To remove all selected LLDP MED TLVs, use the no form of this command.
Syntax
medtlv1
lldp med tlv-select
no lldp med tlv-select
Parameters
medtlv
•
—TLVs that should be included or excluded. Available TLVs are
network-policy, location, poe-pse, and inventory. The capabilities TLV is
always included if LLDP MED is enabled.
Default Configuration
Network-policy TLV
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables LLDP MED with the location TLV on gi5:
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# lldp med tlv-select location
To enable receiving LLDP frames on an interface, use the lldp receive Interface
Configuration mode command.
To stop receiving LLDP frames on an interface, use the no form of this command.
Syntax
lldp receive
medtlv2... medtlv4
[
]
22
326