Programming Special Functions; Dispensing System Settings For Dos Module G 60 Or C 60 (Optional Extras); Setting The Dosage - Miele G 8050 Operating Instructions Manual

Dispensing system settings for
DOS Module G 60 or C 60
(optional extras)
For future servicing work, please
document any alterations to the stan-
dard factory settings. Enter any
alterations in the relevant
Value set:

Setting the dosage:

It is not possible to set the dosage
while a programme is running. You
will have to cancel the programme.
The h/f indicator light must be
flashing.
^ Set the dosage selector on the DOS
module to position 10 (applies to
DOS Module C 60 only).
^ Switch the dishwasher off with the
On/Off button I-0.
^ Press the +c and h/f buttons in
and whilst holding them in switch
the dishwasher on with the On/Off
button I-0.
Then release these buttons.
The "Main wash/Rinses" l indicator
light will come on and the "Salt" k
indicator light will flash.
If this does not happen, start the
procedure from the beginning again.
The set water hardness will then appear
in the display.

Programming special functions

box.
^ Press the +c button once.
The set dispensing time will appear in
the display, e.g. 10 (factory setting).
The c indicator light will come on.
(This shows the programming level)
The k indicator light will flash.
The programming level for the DOS
module has now been called up.
Set the dosage according to the
manufacturer's recommendations.
The machine needs 5.4 litres of water in
the main wash stage of the programme.
Example:
A manufacturer recommends 4 ml
cleaning agent per litre of water:
5.4 l x 4 ml/l = 21.6 ml.
2 ml . 1 second dispensing time; i.e.
programme to 11 seconds.
^ Use the programme selector buttons
%$ to select the value that
corresponds to the dispensing time
you want.
Use the % button to scroll down and
select a lower value.
Use the $ button to scroll up and
increase the value.
The value set will appear in the display.
35