Connecting The Joey Receivers - Dish Network Hopper Sling User Manual

913.book Page 95 Tuesday, January 15, 2013 4:57 PM
Chapter 12
Connecting the Joey Receiver(s)
C
ONNECTING THE
This section describes how to connect the receiver's H
one or more remote TV(s) located in other room(s) away from the Hopper with Sling HD
DVR. You can use these instructions to connect TVs in your whole home to see live and
recorded programming from the system. This installation uses your in-home coaxial cable
system. If your home does not have built-in cabling, it will be necessary to run these
cables from the Hopper with Sling HD DVR to each Joey Receiver conected to a remote
TV. Due to the potential complexity of the system, you should have it professionally
installed. Call the DISH Customer Service Center at 1-800-333-DISH (3474) for more
information.
If you need another remote control, be sure to order the replacement remote-control kit for
the Hopper with Sling HD DVR and Joey Receivers that uses UHF-2G signals. Call your
DISH retailer, or visit the www.mydish.com website, select Upgrades, then Products, and
click on Remote & Accessories.
1
Connect the H
HD DVR to an existing wall cable outlet using a coaxial cable.
2
Connect the Joey Receiver(s) in other room(s) to existing wall cable outlet(s) using
coaxial cable(s).
3
Connect each room's Joey Receiver(s) output jack to an audio/video input of the TV.
•
•
4
Turn on every remote TV and Joey Receiver connected to the in-home cabling system. If
you have not already done so, you should pair a remote control to each Joey Receiver.
5
Follow the on-screen prompts or included instructions for linking each Joey Receiver to
your Hopper with Sling HD DVR. (The Hopper with Sling system is the host equipment for
DISH Whole-Home DVR services.)
6
Confirm that you see a picture from your Joey Receiver(s) on your remote TV(s).
•
•
95
J R
OEY
V N
OME IDEO ETWORK
If it is a high-definition TV or monitor and an HDMI connection is available on the
remote TV, use a single HDMI cable from the output on the back of the Joey Receiver
to provide both high-quality audio and HD/SD video. See page 92.
If it is a standard-definition TV or an HDMI connection is not available on any remote
TV, use composite (yellow) video and (red/white) audio cables from the outputs on the
back of the Joey Receiver. See page 93.
If your picture looks good, then you are finished with this procedure.
If your TVs do not display a picture or if the picture is not as clear as you would like it
to be, repeat the steps to confirm all the connections. All coaxial connections should
be hand-tightened.
( )
ECEIVER S
V N
OME IDEO
output jack on the back panel of the Hopper with Sling
connection to
ETWORK