Remote Code Set Procedure - Automatic Technology Axess Pro Series 1101 Installation Instructions Manual

Remote Code Set Procedure

fi g 42
fi g 43
fi g 44
PRESS
Existing
transmitter
Existing
transmitter
PRESS
New
transmitter
If a transmitter is already coded into the opener,
additional transmitters can be coded without being in
direct contact with the opener's control panel.
NOTE: Only the function of the existing transmitter
button can be assigned to a new transmitter. Please
read instructions prior to proceeding - there is a time-
out facility for security reasons.
Step 1. Selecting The Function To Be Coded
Using the existing transmitter, operate the door with
the transmitter button which has the function to be
coded (Fig. 42) (e.g. Button 1 has been coded with the
OSC function assigned).
Step 2. Wait For Door To Complete Cycle
If the button's function activates the door (PED, SWP,
OSC, CLS, STP or OPN) wait for the door to complete
its cycle.
Step 3. Activate Remote Code Set Mode
Using a small pin, press and hold through the Coding
Hole of the existing transmitter for two seconds
Step 4. Code New Transmitter Button
Within 10 seconds, press the button on the new
transmitter you wish to code for 2 seconds
Step 5. Confi rm Transmitter Button To Be
Coded
Press the same button again (within 10 seconds) for
confi rmation.
Step 6. Test Operation
The new transmitter button should now function as the
existing transmitter.
NOTE: When a transmitter is remote coded, its ID label
is set to that of the existing transmitter. If the existing
transmitter does not have an ID label assigned, then
the ID label of the new transmitter is set to: R/C Tx ###,
where ### is the existing transmitters store number.
This ensures that the originator of any remote coded
transmitter can be identifi ed.
Owner Installation Instructions Axess® Pro Series 1101
(Fig. 43).
(Fig. 44).
27