Special Tools; Hydraulic Tester With Pressure And Flow Capabilities - Toro Reelmaster
4000?D Service Manual

Special Tools

Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Hydraulic Tester − With Pressure and Flow Capabilities − TOR214678
You must have o−ring face seal (ORFS) adapter fittings
for this tester to use it on Toro equipment.
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 − 1000 PSI.
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
Hydraulic System
Figure 12
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 − 5,000 PSI.
5. FLOW METER: This meter measures actual oil flow
in the operation circuit, with a gauge rated at 15 GPM.
6. OUTLET HOSE: Hose from the outlet side of the hy-
draulic tester to be connected to the hydraulic system
circuit.
Page 4 − 26
Rev. C
Reelmaster 4000−D