Specifications - Toro Reelmaster
4000?D Service Manual

Specifications

1
10
1. Drive housing cover
2. drive housing
3. Drive plate shield
4. Grass deflector
Construction: The frame is welded steel. The reel uses
heavy duty, self−aligning ball bearings. The heavy duty
steel rear roller has tapered roller bearings. The rear
roller and bedbar are isolated and mounted in rubber
bushings for quiet, vibration−free operation. Adjustable
deflector shields are standard. Stainless steel compo-
nents are used at key points for added durability.
Reel Configuration: The 5, 7, and 11 blade heavy duty
welded reels all have 8 inch (20.3 cm) diameters and are
29−3/4 in. (75.5 cm) wide.
Bedknife/Bedbar Assembly: A replaceable, single
edged, alloy steel bedknife is induction hardened. The
bedknife is fastened with steel screws to a precision
ground surface on the high strength, fabricated steel
bedbar. The stress−relieved machined bedbar is
mounted with four (4) vibration isolation bushings.
Bedknife to Reel Adjustment: Two lockable lead
screw adjusters at each side of the frame adjust the reel
to bedknife contact.
Rear Roller: 3−1/2 inch (89 mm) diameter steel roller
has greaseable tapered roller bearings. A double lip oil
seal and wear sleeve isolates grit and moisture from the
bearings.
Cutting Units
2
4
3
9
5. Rear roller adjuster (both ends)
6. Reel−to−bedknife adjuster
7. Guard
8. cone nut
11
Figure 1
Height−of−Cut: 5 Blade − 1 to 3 inches (25 to 76 mm).
7 Blade − 1/2 to 1−3/4 inch (9.5 to 45 mm). 11 Blade −
3/8 to 3/4 inch (9.5 to 19 mm).
Height−of−Cut Adjustment: Quick adjustment and
positive locking is provided by locking type cone nuts.
Gauge marks of 1/4 inch (6.3 mm) are provided as a ref-
erence for easy changes of height−of−cut.
Clip (variable to match cutting conditions):
5 Blade Cutting Unit: 0.176 inch per mph
(0.352 inch at 2 mph to 1.32 inch at 7.5 mph)
7 Blade Cutting Unit: 0.1 26 inch per mph
(0.252 inch at 2 mph to 0.945 inch at 7.5 mph)
11 Blade Cutting Unit: 0.080 inch per mph
(0.16 inch at 2 mph to 0.600 inch at 7.5 mph)
Lubrication: Easily accessible grease fittings for bear-
ings and all major pivot points are provided.
Drive: The reel drive motor turns a maintenance−free
cog belt that drives the reel. Drive pulley and cog belt are
encased in a drive housing for safety and protection
from contamination.
Grass Deflector Shields: Shields are fully adjustable.
Page 7 − 2
6
9. Reel
10. Optional front roller
11. Top covers
Reelmaster 4000−D
5
7
8