Date And Time Set Up - Worcester Greenstar Comfort II RF Installation And Operating Instructions Manual

Radio frequency twin channel programmable room thermostat and receiver

Hide thumbs

Table Of Contents

Table of Contents

Wall mounting plate

To remove the wall mounting plate:

1. Insert a suitable flat bladed screwdriver into the slot on the

bottom edge of the thermostat

2. Twist the screwdriver gently until the bottom catch is

released.

3. Remove the wall plate from the programmable room

thermostat.

Fig. 6

Remove back plate

Wall mounting

Before mounting the room Programmable room thermostat on

the wall, it is good practice to find a position that affords good

signal strength.

If the signal strength is low, try another position in that room

until the best possible signal strength is obtained, refer to

section 5.1 to enter the User menu and then the paragraph

Signal strength in section 5.1.4.

Using the wall plate as a template, mark the position of the

mounting screws.

The wall mounting kit provided with the Programmable room

thermostat contains:

•

2 x countersunk screws

•

2 x plastic wall plugs

▶ Drill two holes to suit the size and depth of the wall plugs

▶ Fit the wall plugs

▶ Fit the screws, but leave a sufficient amount proud to allow

the wall plate to be fitted over the screw heads

▶ Fit the wall plate, ensuring that it is level and tighten the

screws to secure

Comfort II– 6720810965 (2014/07)

6720810965-09.1Wo

Fig. 7

Wall plate mounting

Fitting the batteries

Ensure that the batteries are the correct type

(LR6/AA) and oriented as shown in figure 8

▶ Insert the batteries ensuring that the positive + end of the

battery is inserted into the positive + terminal of the holder.

Fig. 8

Fitting the batteries

▶ Fit the thermostat to the wall plate, locating the catches [1]

on the top edge and then snap the bottom edge into place

3.3