Alignment Instructions - Sanyo LED-22XR10F Service Manual

Alignment instructions

1. Safety Instructions
Be sure to switch off the power supply before replacing or welding any components or
inserting/plugging in connection wire Anti static measures to be taken (throughout the entire
production process!):
a) Do not touch here and there by hand at will;
b) Be sure to use anti static electric iron;
c) It's a must for the welder to wear anti static gloves.
Please refer to the detailed list before replacing components that have special safety requirements.
Do not change the specs and type at will.
2. Test equipment
VG-848 (VGA, YPbPr signal generator)
VG-849 (HDMI digital video signal generator)
CA210 (color analyzer)
3 Alignment flow
3.1 Voltage of power supply test
According to the wiring diagram "9219KH7201JL", connect power board, main board, IR board
correctly, then switch on main power and press key "standby" to turn on the TV set.
a) Test each pin voltage of socket X401 in turn, please refer voltage to Table 1:
X401 Pin1
Vol. 4.9 V～5.1 V
2 3 4，5
11.4 V～
3.2 V～3.4 V 0
12.6 V
Table 1
6 7 8
4.85
0 0 0
5.35 V
Each pin voltage of X401
9 10 11
V ～ 4.85 V～5.35
0
V
12 13
0 >2.5 V