Pro1 IAQ T701 Installation Manual
Pro1 iaq t701 thermostat installation manual
Hide thumbs
Also See for T701:
- Installation manual (10 pages) ,
- Operating manual (4 pages) ,
- Operation manual (6 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Need help?
Do you have a question about the T701 and is the answer not in the manual?
Questions and answers
What would cause my AC to run when I **** calling for heat causing my AC coil to ice up
How to remove thermostat from wall
To remove the Pro1 IAQ T701 thermostat from the wall, follow these steps:
1. Turn off the power to the HVAC system to prevent electrical hazards.
2. Locate the thermostat's cover and gently pull it off from the base.
3. Identify the screws securing the thermostat base to the wall.
4. Use a screwdriver to remove the screws.
5. Carefully disconnect the wiring from the thermostat terminals, noting their positions for reinstallation.
6. Lift the thermostat base off the wall.
Always handle the wiring carefully to avoid damage.
This answer is automatically generated
How do I set the T701 thermostat to go below 68 degrees in cooling mode?
The Pro1 IAQ T701 thermostat allows you to adjust the temperature using the up and down buttons. To set it below 68°F in cooling mode, follow these steps:
1. Ensure the thermostat is set to Cool mode by pressing the System button until "Cool" appears on the display.
2. Use the down arrow button to lower the temperature setting below 68°F.
3. The display will show the selected setpoint temperature.
If the thermostat does not allow the temperature to go below 68°F, check if any limits are set in the configuration settings.
This answer is automatically generated