Pro1 IAQ t755 Installation Manual
Hide thumbs Also See for t755:

Advertisement

T755
Pro1 Technologies, Inc.
1111 S. Glenstone Ave., Suite 2-100
Spring eld, MO 65804
Toll-Free:
1-888-776-1427
Hours of Operation: M-F 9AM - 6PM Eastern
Thermostat Applications Guide
Description
Gas or Oil Heat
Electric Furnace
Heat Pump (No Aux. or Emergency Heat)
Heat Pump (with Aux. or Emergency Heat)
Multi-stage Systems
Heat Only Systems
Cool Only Systems
Millivolt

Table of Contents

® U.S. Registered Trademark. Patents pending.
Copyright © 2015 All rights reserved.
Web: www.pro1iaq.com
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Page
2
3
4
5-6
7-9
10
11-12
13
INSTALLATION MANUAL
Power Type
Battery Power
Hardwire (Common WIre)
Hardwire (common Wire) with Battery Backup
A trained, experienced technician
must install this product.
Carefully read these instructions. You
could damage this product or cause a
hazardous condition if you fail to follow
these instrucions.
Una versión en español de este
manual se puede descargar en la
página web de la compañía.
Rev. 1517
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the t755 and is the answer not in the manual?

Questions and answers

Summary of Contents for Pro1 IAQ t755

  • Page 1: Table Of Contents

    INSTALLATION MANUAL T755 Pro1 Technologies, Inc. 1111 S. Glenstone Ave., Suite 2-100 Spring eld, MO 65804 Toll-Free: Web: www.pro1iaq.com 1-888-776-1427 Hours of Operation: M-F 9AM - 6PM Eastern Power Type Thermostat Applications Guide Battery Power Description Hardwire (Common WIre) Gas or Oil Heat...
  • Page 2: Installation Tips

    INSTALLATION TIPS Wall Locations The thermostat should be installed approximately 4 to 5 feet above the oor. Select an area with aver- age temperature and good air circulation. Do not install thermostat in locations: • Close to hot or cold air ducts •...
  • Page 3: Thermostat Quick Reference

    THERMOSTAT QUICK REFERENCE Getting to know your thermostat Displays the user Days of the week selectable setpoint and time temperature. HOLD is displayed when thermostat program is permanently overridden. Menu Options: Shows different options Low Battery Indicator: Replace batteries when this indicator is shown.
  • Page 4: Subbase Installation

    SUBBASE INSTALLATION Caution: Mercury Notice: Electrical Hazard All of our products are mercury free. However, if the product you Failure to disconnect the power are replacing contains mercury, before beginning to install this dispose of it properly. Your local product can cause electrical waste management authority can shock or equipment damage.
  • Page 5: Wiring

    WIRING New Thermostat Installation Wiring Power supply. Factory -installed jumper. Remove only when installing on 2-transformer systems. Use either O or B terminals for changeover valve. Optional 24 VAC common connection when thermostat is used in battery power mode. Typical 2H/2C system: 1 transformer Typical 2H/2C system: 2 transformer REMOVE JUMPER L1 (HOT)

Table of Contents