Sony Trimaster EL BVM-E250 Operation Manual page 62

Menu
Line Color
Line Bright
Wipe
Line Display
Line Color
Line Bright
Position
Butterfly
Line Display
Line Color
Line Bright
Position
Blending
Blending Ratio
Pixel Zoom Setting
Line Color
Gamut Error Display
Gamut Error Display
62
Function Setting Menu
Function and operation ([
Sets the boundary line color of two pictures.
You can select from [White] (white), Red (red), Green (green), Blue (blue), Yellow (yellow),
Cyan (cyan), Magenta (magenta) or Black (black).
Sets the luminance of the boundary line.
You can select from High (bright) or [Low] (dark).
Sets the wipe display.
Sets display mode of the boundary line.
[Auto]: Appears when the position of the boundary line is set and disappears after a
while.
On: Always displayed.
Off: Not displayed.
Sets the boundary line color.
You can select from [White] (white), Red (red), Green (green), Blue (blue), Yellow (yellow),
Cyan (cyan) or Magenta (magenta) or Black (black).
Sets the luminance of the boundary line.
You can select from High (bright) or [Low] (dark).
Sets the position of the boundary line.
Set to –100 (leftward) to +100 (rightward). [000]
Sets the butterfly display.
Sets display mode of the boundary line.
Off: Not displayed.
[On]: Always displayed.
Sets the boundary line color.
You can select from [White] (white), Red (red), Green (green), Blue (blue), Yellow (yellow),
Cyan (cyan) or Magenta (magenta) or Black (black).
Sets the luminance of the boundary line.
You can select from High (bright) or [Low] (dark).
Sets the position of the boundary line.
Set to –100 to +100. [000]
Sets the blending display.
Sets the blending ratio when two images are mixed.
Set to 000 (Signal A disappears.) to 100% (Signal B disappears). [050]
Sets the pixel zoom.
Sets the boundary line color.
You can select from [White] (white), Red (red), Green (green), Blue (blue), Yellow (yellow),
Cyan (cyan) or Magenta (magenta) or Black (black).
Sets the gamut error display.
A zebra pattern is superimposed on the portion where an error is detected.
Notes
• The gamut error display function is effective when the input signal is 3G/HD/SD SDI, HDMI,
or DisplayPort (and the quantization range for the signal is Limit). It is effective regardless
of the signal format, when Gamma is set to S-LOG Standard or S-LOG Full in the Color
Profile menu.
• The gamut error display function does not work in the following cases:
- When the input signal has no sync signal
- When the internal signal is displayed
- When H Delay/V Delay is set to On
- When Side by Side, Wipe, Butterfly or Blending is set to On
• In under scan mode, each one line of the upper and lower lines of the video signal is also
detected for gamut error display.
• The time code display, the closed caption display when the BKM-244CC is installed, and
the embedded audio level display when the BKM-250TG is installed are also detected for
gamut error display.
• In over scan mode, 5% mask portion is also detected for gamut error display. However, the
zebra pattern is not displayed on 5% mask portion.
Sets whether or not to display the gamut error ([Off] or On).
]: factory setting)