Connections; Preparations For Editing - Sony XDS-1000 Operation Manual

Note
Editing of the MPEG HD420 format is not supported.
Editable video and audio signals
This unit supports editing of the following signals on video
and audio tracks.
• Video
- HD-SDI (for HD recording)
- SD-SDI (for SD recording)
• Audio
- SDI
- Analog
- AES/EBU
Notes
• Editing cannot be done with a CIFS connection.
• Recording of upconverted SD is not supported.
Supported media
Editing is possible on the internal storage only.

Connections

Make connections in the same way as for a cut editing
system (see page 34).
When making the connections, also refer to the operation
manuals provided with the equipment to be connected.

Preparations for editing

Recording format settings
Before performing clip editing, you need to set the
recording format of the units to match the recording format
of the editing target clip. The following table shows the
required settings.
Item Setting
Recording format Check the recording format of the clip
with the display window (see page 23)
and select the same format with setup
menu item 031 RECORDING FORMAT.
Item Setting
Audio/Non-audio To perform insert editing of non-audio
(data) (data), set maintenance menu item
M37: AUDIO CONFIG >M372: NON-
AUDIO INPUT to "data".
Notes
• When you insert non-audio into a clip,
the channels containing the non-
audio are treated as non-audio
across their entire length.
• Use channel pairs (CH1/2, CH3/4,
CH5/6, CH7/8) for non-audio insert
editing. Non-audio editing is not
executed unless a channel pair is
specified.
See page 94 for more information about setup menu
operations.
See page 117 for more information about maintenance
menu operations.
Settings required for editing
The following table shows the settings required for editing.
Item Setting
Video input signal Select the video input signal with V
INPUT on page P1 INPUT of the
function menu.
Audio input signal Select the audio input signal with A1
INPUT to A4 INPUT on the P1 INPUT
page and with A5 INPUT to A8 INPUT
on the P2 INPUT page of the function
menu.
Input audio level Adjust the input audio level with the
CH-1/ALL CH and CH-2 to CH-4
knobs.
Edit point transition With setup menu item 317 AUDIO
type EDIT MODE, select "cut edit" or "cross
fade".
Time code • With TCG on page P4 TC of the
function menu, select "INT".
• With PRST/RGN on page P4 TC of
the function menu, select
"PRESET".
• With RUN MODE on page P4 TC of
the function menu, select "FREE
RUN".
Repeat playback With setup menu item 142 REPEAT
mode MODE, select "off".
See page 117 for more information about maintenance
menu operations.
See page 44 for more information about function menu
operations.
See page 94 for more information about setup menu
operations.
53
Linear Editing