Beta Marine BV1305 Operation And Maintenance Manual page 35

TYPICAL STARTER MOTOR RATINGS:-
Starters used in Kubota engines have the following standard capacities
Engine
1000cc to 1500cc
SUGGESTED MINIMUM ENGINE STARTER BATTERY SIZE:
Engine (cc) Typical Battery Capacity (AH)
BD1005
BV1305
BV1505
KEYSWITCH TERMINATIONS
The standard panel keyswitch can be
used to tap off a switched positive
ignition feed to power additional
gauges. In this way these gauges will
only be live whilst the engine is
running, the engine is starting or the
heaters are being used.
For silver keyswitches, the terminal
to achieve this ignition switched
positive is marked ' A C'.
Starter capacity (kW)
1.2
at a 20hr Rate
65 ~ 75
70 ~ 75
70 ~ 75
For black keyswitches, the terminal
to achieve this ignition switched
positive is marked '15/54'.
For panels without any keyswitch,
gauges can be driven from the 1mm
brown wire which terminates at 11
way connector terminal 4. This is a
low power switched positive, any
additional power required from this
connection must be fed through a
relay, as noted below.
Typical C.C.A. (A)
Cold Cranking Amperage
450 ~ 540
450 ~ 540
450 ~ 540
2
Note: these terminals are rated at 10
amps maximum, since they are
already utilised for panel and
alternator feeds Beta Marine
recommend any additional
requirements from these terminals
must be fed through a relay. This
relay should then be connected to it's
own fused positive supply directly
from the engine battery. Beta drawing
202-06421 illustrating the wiring of
a typical electric fuel lift pump with
ignition switched relay can be
supplied upon request.