How To Detach And Attach The Quick Joint - Mitsubishi Electric EHSD-MEC.UK Service Manual

DISASSEMBLY PROCEDURE

15. How to detach and attach the quick joint

Refer to the following steps when detaching and attaching the
quick connection.
(1) Remove the clip. (Photos 15-1 and 15-2)
(2) Separate the connected parts to remove the O-ring. (Photo
15-3)
• Do not reuse the removed O-ring.
• Wipe off if dirt or foreign matters are found on the sealing
surface where the O-ring touches.
(3) Apply grease on the O-ring using a plastic bag, etc. (Photo
15-4)
(4) Attach the O-ring to the male part of quick connection. (Pho-
to 15-5)
• Keep the O-ring free from dirt or foreign matters.
(5) Connect the male and female parts of the quick connection.
(Photo 15-6)
(6) Attach the clip. (Photo 15-7)
• Ensure to attach the wider diameter of the clip to the fe-
male side. Failure to do so, it may cause water leak at the
connected part. (Photo 15-8)
Photo 15-3
Female Male
Photo 15-6
OCH571
Photo 15-4
O-ring
Photo 15-7
77
PHOTOS & ILLUSTRATION
Photo 15-1
Photo 15-2
Clip
Photo 15-5
Plastic
bag
O-ring
Photo 15-8
Clip
Clip
Gap