DISASSEMBLY PROCEDURE
8. How to remove the plate heat exchanger(continued)
<E*SD series>
(12) Remove the flare nuts on the gas and liquid pipes
under the hydrobox using two spanners: one to hold
each flare joint and the other to turn each flare nut.
(13) Remove the plate heat exchanger with water coil cover
by lifting it upward after removing the 2 screws on the
water coil cover. (Photos 8-7 and 8-8)
(14) Remove the water coil cover and the water coil base by
removing the 6 screws. (Photo 8-9)
OCH571
PHOTOS
Photo 8-8(E*SD series)
Plate heat exchanger
Photo 8-9(E*SD series)
Water coil base
Water coil cover
Screws
70
Pump support
Plate heat exchanger
assembly (inside)
Screws