Fujitsu ETERNUS DX60 S2 User Manual page 66

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
■ For regions other than EMEA&I
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
(5)
Push the M5 cage nuts into the 2nd holes of the front rack pillars above the base line of
the drive enclosure.
The M5 centering screw and M5 pan head screw positions for the slide rails and 2U
rack rail are determined relatively to the base line of the drive enclosure.
Tighten the screws referring to the following figure.
[Left]
3rd position
(M5 centering screw)
2nd position
2U
(M5 cage nut)
1st position
(M5 pan head screw)
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the
rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance
between the front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the
rack rail must be attached to the rack before they can be completely tightened.
Rack rail (for left side)
"L" is stamped on the inner
side of the rack rail
[Left]
(for left side).
(Front rack pillars)
[Right]
Copyright 2014 FUJITSU LIMITED
[Right]
Drive enclosure
(M5 pan head screw)
Base line of
drive enclosure
Rack rails
(Rear rack pillars)
Loosen the M4 screws, and
adjust the rack rails to the depth
of the rack.
Rack rail (for right side)
"R" is stamped on the inner
side of the rack rail
(for right side).
66
3rd position
(M5 centering screw)
2nd position
(M5 cage nut)
1st position
P3AM-5512-07ENZ0