Samsung SCB-5003 User Manual page 29

DURATION : This function is used to select the brightness of light where

GAIN LEVEL
VERY SLOW
SLOW
NORMAL
FAST
VERY FAST
※ D epending on the installation environment and the exposure menu's gain
mode setting, the switching brightness may vary.
DWELL TIME : You can select day/night switching delay time from.

M
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night mode to auto.
When a bright light source is in the screen or there are frequent brightness changes, if you use the
auto night/day mode, and set the switching time to short (3, 5 sec), a hunting can be caused. In this
situation, it is recommended to use the default setting (30 sec).
- EXTERN : Ground to the grounding terminal to allow automatic switching between
COLOR and B/W (Black/White).
- COLOR : The picture is always displayed in color.
- B/W : The picture is always displayed in black and white.
You can turn on or off the burst signal on B/W mode.
M
If the lens mounted in the camera is different from the one set in <LENS> of the
<EXPOSURE> menu, then the night/day mode may not operate normally.
DEfog : You can use the defog mode to allow the camera to automatically

detect the fog density of the screen and display a clear image despite
smog, fog or general poor visibility.
❶ If the SPECIAL menu screen is displayed, use the Function Setup switch so that
the arrow indicates 'DEFOG'.
❷ Select a desired mode using the Function Setup switch.
- AUTO : Adjust the level automatically.
- Manual : Depending on the defog
level set by the user,
adjust the clarity of image.
(LOW, MIDDLE, HIGH)
- OFF : Released state
switching occurs.
LOW
Color→B/W B/W→Color Color→B/W B/W→Color Color→B/W B/W→Color
2.4 5.2
2.5 5
2.6 4.9
2.7 4.8
2.8 4.7
→ 3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
MID
1.5 5.6
1.8 5.4
2.1 5.2
2.4 5
2.7 4.8
DEFOG MANUAL SETUP
LEVEL
▶ 1.
RETURN
2.
HIGH
0.6 6.2
1.1 6
1.6 5.8
2.1 5.4
2.6 5
MIDDLE
English_2