Samsung SCB-5003 User Manual page 25

hlC (high light Compensation) :

This function masks the strong light
to minimize white out due to over
exposure and preserve much of the
on-screen details when the camera
aims a strong light source.
- LEVEL : Adjusts the brightness
level of a monitoring area.
- LIMIT : Enable to change the
operating condition.
- MASK COLOR /TONE :
Change the color / brightness of the masking area.
(Black, Red, Blue, Cyan, Magenta)
- TOP/BOTTOM/LEFT/RIGHT : Adjust the area to be enhanced.
- RETURN : Return to the MAIN SETUP menu.
M
If the white balance menu is set to manual, then HLC performance can be limited.
If you use the defog and HLC functions at the same time, saturation can occur in a bright environment.
Because there can be a difference in the effectiveness of HLC according to the amount of light
area in the screen, optimize the installation angle for the best HLC performance.
When dark, the HLC is only activated when a bright light exceeding a specifi c size. (In NIGHT ONLY mode).
The HLC is not activated in day light or when bright light is not present at night. (In NIGHT ONLY mode).
WDr : When there are both bright and

dark areas at the same time,
this mode makes both areas
distinctive.
- LEVEL : Select one from low,
med, high to adjust the brightness of the WDR setup.
- RETURN : Return to the MAIN SETUP menu.
M
In WDR mode, the max/min shutter value is set to 1/2 to 1/240.
In WDR mode, there can be noise between a bright and dark area.
Depending on light conditions, unnatural changes or symptoms can occur on the
screen so deactivate the user mode.
<WDR ON>
HLC SETUP
LEVEL
▶ 1.
LIMIT
2.
MASK COLOR
3.
MASK TONE
4.
TOP
5.
BOTTOM
6.
LEFT
7.
RIGHT
8.
RETURN
9.
WDR SETUP
LEVEL
▶ 1.
RETURN
2.
<WDR OFF>
MIDDLE
NIGHT ONLY
BLACK
- ------- 5

-- ------ 30

------ -- 75

-- ------ 30

------ -- 75

MIDDLE
English_2