Siemens RDH10 How To Use

Digital room thermostat

Hide thumbs Also See for RDH10:

How to use your Siemens RDH10/RDH10RF

Digital Room Thermostat

Guide to symbols

On LCD Display

Actual room temperature in °C

The selected temperature

Indicates there is a call for heat

Indication of low battery life, this signifies batteries must be replaced

This leaflet gives you easy to follow instructions on how to use your RDH10 digital room thermostat.

LCD Display

Rotary Dial

Batteries Compartment

Technical Helpline: 0870 850 0184

The RESET button on the back of the controller can be pressed to return the controller

to the factory settings

How do I set the required temperature?

Turn the rotary dial to the left to decrease the

required temperature, or to the right to increase the

required temperature.

The required temperature is displayed next to the

following symbol

PKGPT01020A

Table of Contents

Need help?

Do you have a question about the RDH10 and is the answer not in the manual?

Page 1 How to use your Siemens RDH10/RDH10RF This leaflet gives you easy to follow instructions on how to use your RDH10 digital room thermostat. Digital Room Thermostat How do I set the required temperature? Turn the rotary dial to the left to decrease the required temperature, or to the right to increase the required temperature.
Page 2 Mounting & wiring Instructions for the Siemens RDH10 Digital Room Thermostat Wiring Diagram Legend = Common = Live feed to item to be controlled = Changeover contact Technical Helpline: 0870 850 0184...
Page 3 4000V Mounting Instructions The controller can be wall mounted. The RDH10 should be located such that it can acquire the room temperature as accurately as possible, without being affected by direct solar radiation or other heat or refrigeration sources. Check wiring All electrical connections must comply with current regulations.
Page 4 SIEMENS RDH10.1 & RDJ10.1, BATTERY POWERED UNITS COMMON SWITCH LIVE TERMINAL SATISFIED TERMINAL (To Boiler, Pump or Valve) TERMINAL (Live Input) SEE NOTE BELOW (Not Normally Used) LX L1 L2 RDH10.1 & RDJ10.1 BACK PLATE NOTE. LX, L1 & L2, ARE ‘VOLTS FREE,’ CONTACTS.

Rdh10rf