Toshiba e-STUDIO203 Service Handbook page 38

Procedure 6
[0][5]
[Digital keys]
[POWER]
Procedure 7
[0][5]
[POWER] [Digital keys]
Procedure 17
[0][5]
[POWER] [Digital keys]
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
e-STUDIO163/203 ERROR CODE AND SELF-DIAGNOSTIC MODE
Code
[START]
Code
[START]
Code
[START]
Automatic
adjustment Does not store
value in RAM
[INTERRUPT]
Automatic
adjustment
Does not store
value in RAM
[FUNCTION
value in RAM
Automatic
[INTERRUPT]
adjustment
Does not store
value in RAM
[FUNCTION
Adjustment
[25%] / [200%]
2 - 18
Error
[FUNCTION
CLEAR]
value in RAM [POWER]
[FUNCTION OFF/ON
CLEAR]
Error
[CLEAR]
Stores
[POWER]
OFF/ON
CLEAR]
Start
[START]
Stores
[POWER]
OFF/ON
CLEAR]
Set manually
December 2005 © TOSHIBA TEC